How Do I Leveling the SW1?

Reset the Feet with the Rear Lower than the Front

  1. Screw the rear leveling foot in until it just touches the base.
  2. Adjust the the front leveling feet until they are about two turns (1 mm) from the base.
  3. Place the cradle near to the left stop and release it. The cradle should swing to the stop. If not, raise both front feet and repeat until it does.
  4. Repeat step 3 near the right stop.

Adjust Right-to-Left Level

  1. Place the cradle in the middle and release it. If the cradle swings one direction, raise that side and repeat until it stays in the middle.

Adjust Front-to-Rear Level and Fine-Tune

  1. Place the cradle near to the left stop and release it. It will swing to the stop. Raise the rear and repeat until the cradle remains nearly stationary.
  2. The device should now be nearly level. Verify that the cradle remains nearly stationary in the other positions, and if not, fine-tune the leveling feet until it does.
Back⏎